Wac Port Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
Virtual IPv6
HTTP(S) Ports(1-
65535)
RADIUS Authorization
Local Authorization
Click Apply to the implement changes.

WAC Port Settings

This window is used to enable and configure Web-based Access Control Port Settings on the Switch.
To view this window, click Security > Web-based Access control (WAC) > WAC Port Settings, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Enter a virtual IPv6 address so that the TCP packets sent to the virtual IP for IPv6 will get a
reply. If the virtual IP for IPv6 is enabled, the TCP packets sent to the virtual IP or physical
IPIF's IPv6 address will both get a reply. When the virtual IPv6 is set to ::, the function is
disabled. To ensure that this function works correctly, the virtual IPv6 address must not be
configured to be an IPv6 address that exists on the subnet.
This function specifies the TCP port that will be used to identify the HTTP or HTTPS
packets to be trapped to the CPU for the authentication process.
Select either HTTP or HTTPS and enter the ports.
HTTP – Specifies that the TCP port will run the WAC HTTP protocol. The default value is
80. HTTP port cannot run at TCP port 443.
HTTPS – Specifies that the TCP port will run the WAC HTTPS protocol. The default value
is 443. HTTPS cannot run at TCP port 80.
If no protocol is specified the protocol used is HTTP.
WAC Authorization Network Settings
Specifies to Enable or Disable RADIUS Authorization.
Specifies to Enable or Disable Local Authorization.
324