Dhcp/Bootp Relay Interface Settings; Dhcp Relay Option 60 Default Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack

DHCP/BOOTP Relay Interface Settings

This window allows the user to set up a server, by IP address, for relaying DHCP/ BOOTP information. The user may enter a
previously configured IP interface on the Switch that will indicate which interface is able to support the dhcp relay function.
Properly configured settings will be displayed in the BOOTP Relay Table at the bottom of the following window, once the user
clicks the Add button under the Apply heading. The user may add up to four server IPs per IP interface on the Switch.
To view this window, click Administration > DHCP/BOOTP Relay > DHCP/BOOTP Relay Interface Settings as shown
below.
The following parameters can be configured or viewed:
Parameter Description
Interface The IP interface on the Switch that will be connected directly to the client.
Server IP Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured per IP
Interface
Click Add to include this Server To remove an entry, click the corresponding

DHCP Relay Option 60 Default Settings

This window allows the user to configure the DHCP Relay Option 60 Default servers. When there are no matching servers found
for the packet based on option 60, the relay servers will be determined by the default relay server setting. Similarly, when there is
no match found for the packet, the relay servers will be determined based on the default relay servers.
To view this window, click Administration > DHCP/BOOTP Relay > DHCP Relay Option 60 Default Settings, as shown
below.
The following parameters can be configured:
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 70 DHCP/BOOTP Relay Interface Settings window
Figure 2 - 71 DHCP Relay Option 60 Default Settings window
button.
73