System Log Save Mode Settings; System Log Source Interface Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack

System Log Save Mode Settings

This window may be used to choose a method for which to save the switch log to the flash memory on the Switch.
To view this window, click Administration > System Log > System Log Save Mode Settings, as shown below.
The following parameters can be configured:
Parameter Description
Save Mode Use the pull-down menu to choose the method for saving the switch log to the Flash memory.
There are three options:
Time Interval – Configure a time interval by which the switch will save the log files.
On Demand – Only save log files when manually telling the Switch to do so. Go to Save
Services > Save Changes to manually save log.
On Trigger – Save log files to the Switch every time when a log event occurs on the Switch.
Minute(s) When Time Interval is selected in Save Mode, set a time between 1 and 65535 minutes in the
field. The default value is 1 minute.
Click Apply to implement the changes. Click Save Log Now to immediately save log files currently on the Switch.

System Log Source Interface Settings

This window may be used to choose a method for which to save the switch log to the flash memory on the Switch.
To view this window, click Administration > System Log > System Log Source Interface Settings, as shown below.
The following parameters can be configured:
Parameter Description
Interface Name
Enter the name of the interface.
IPv4 Address Tick the check box and enter the IPv4 address.
Click Apply to add the entry to the Syslog Source Interface Table. Click
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 39 System Log Save Mode Settings window
Figure 2 - 40 System Log Save Mode Settings window
to remove the corresponding entry.
46