D-Link xStack DGS-3400 Series Reference Manual page 245
Web ui reference guide for layer 2+ managed gigabit ethernet switch
Hide thumbs
Also See for xStack DGS-3400 Series:
- Reference manual (629 pages) ,
- Cli reference manual (540 pages) ,
- Cli manual (463 pages)
Table of Contents
Advertisement
x Stack
Enter a VLAN ID in the R-APS VID (1-4094) field, and click Apply to see the entry appears in ERPS RAPS VLAN Table
window.
To edit an entry, click Modify to see the window shown below.
The following fields can be set:
Parameter
ERPS State
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 3 - 78 ERPS RAPS VLAN Table - Add window
Figure 3 - 79 ERPS RAPS VLAN Table - Edit window
Description
This is used to configure ring state of the specified ring. When both the global state and the
specified ring ERPS state are enabled, the specified ring will be activated. STP and LBD
should be disabled on the ring ports before the specified ring is activated. The ring cannot be
enabled before the R-APS VLAN is created, and ring ports, RPL port, RPL owner, are
configured. Note that these parameters cannot be changed when the ring is activated. The
default ring state is Disabled.
232
Advertisement
Table of Contents
