D-Link xStack DGS-3400 Series Reference Manual page 304

x Stack
Figure 5 - 46 CPU Interface Filtering Rule Table window (IPv6)
To create a new rule set for an access profile click the Add Rule button. A new window is displayed. To remove a previously
created rule, click the corresponding
Figure 5 - 47 CPU Interface Filtering Rule Configuration window (IPv6)
Configure the following Access Rule Configuration settings for IPv6:
Parameter Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the Switch
and will be filtered.
Access ID (1-100) Type in a unique identifier number for this access. This value can be set from 1 to 100.
Type Specifies the type of profile that is being created.
Class (0-255) Entering a value between 0 and 255 will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of Service (ToS)
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
button. The following window is used for the IP Rule configuration.
291