Poe System Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
Based on 802.3af/at PDs receive power according to the following classification
Class
0
1
2
3
To configure the PoE features on the DGS-3426P, click Administration > PoE. The PoE System Settings window is used to
assign a power limit and power disconnect method for the whole PoE system. To configure the Power Limit for the PoE system,
enter a value between 37W and 370W for the DGS-3426P in the Power Limit field. The default setting is 370W. When the total
consumed power exceeds the power limit, the PoE controller (located in the PSE) disconnects the power to prevent overloading
the power supply.

PoE System Settings

This window is used to configure PoE settings on the Switch.
To view this window, click Administration > PoE > PoE System Settings, as shown below.
The following parameters can be configured:
Parameter
Unit
Power Limit (37-
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Maximum power available to PD
12.95W
3.84W
6.49W
12.95W
Figure 2 - 133 PoE System Settings window
Description
Choose the switch in the switch stack for which to configure the PoE settings.
Users should note that not all switches in the xStack
when they are configured in a stack, the Primary Master switch will display the PoE settings to
be configured for the stack, whether or not the Switch is a PoE supported device. However,
only PoE supported switches have the PoE capability in the switch stack.
Sets the limit of power to be used from the Switch's power source to PoE ports. The user may
:
PSE provides power according to the following classification:
Class
0
1
2
3
User define
®
DGS-3400 Series support PoE yet,
115
Max power used by
PSE
15.4W
4.0W
7.0W
15.4W
16.8W