Dhcp Server Pool Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
The following parameters may be configured:
Parameter Description
Begin Address Enter the starting IP address of the range of IP addresses to be excluded from the DHCP pool.
End Address Enter the final IP address of the range of IP addresses to be excluded from the DHCP pool.
Click Apply to implement changes made. To remove any entry, click the corresponding
Clear All.

DHCP Server Pool Settings

The following windows will allow users to create and then set the parameters for the DHCP Pool of the switch's DHCP server.
To view the following window, click Administration > DHCP Server > DHCP Server Pool Settings, as shown below.
Users must first create the pool by entering a name of up to 12 alphanumeric characters into the Pool Name field and clicking
Apply. To remove an entry in the table, click the corresponding
Server Pool Table, click the corresponding Modify button to reveal the following window:
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 83 Create DHCP Excluded Address window
Figure 2 - 84 Create DHCP Pool window
button. To configure the settings of a pool in the DHCP
81
button. To delete all the entries, click