D-Link xStack DGS-3400 Series Reference Manual page 218
Web ui reference guide for layer 2+ managed gigabit ethernet switch
Hide thumbs
Also See for xStack DGS-3400 Series:
- Reference manual (629 pages) ,
- Cli reference manual (540 pages) ,
- Cli manual (463 pages)
Table of Contents
Advertisement
x Stack
To view this window, click L2 Features > Spanning Tree > STP Instance Settings, as shown below.
The following information is displayed:
Parameter
Instance Type
Instance Status
Instance Priority
Click the Modify button to change the priority of the MSTI. This will open the Instance ID Settings window to configure.
Parameter
MSTI ID
Displays the MSTI ID of the instance being Modified. An entry of 0 in this field denotes the CIST
(default MSTI).
Type
The Type field in this window will be permanently set to Set Priority Only.
Priority (0-61440)
Enter the new priority in the Priority field
Click Apply to implement the new priority setting.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 3 - 54 STP Instance Settings window
Description
Displays the instance type(s) currently configured on the Switch. Each instance type is
classified by a MSTI ID. CIST refers to the default MSTI configuration set on the Switch.
Displays the current status of the corresponding MSTI ID
Displays the priority of the corresponding MSTI ID. The lowest priority will be the root bridge.
Figure 3 - 55 STP Instance Settings- Edit window
Description
205
Advertisement
Table of Contents
