x Stack
The following parameters can be configured:
Parameter
Unit
From / To
High Alarm (0-131)
Low Alarm (0-131)
High Warnin (0-
131)
Low Waring (0-
131)
Click Apply to implement the changes.
DDM TX Power Threshold Settings
This window is used to configure the threshold of Tx power for specific ports on the Switch.
To view this window, click Administration > Port Configuration > DDM > DDM TX Power Threshold Settings, as shown
below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 24 DDM Bias Current Threshold Settings window
Description
Select the unit to configure.
Select a range of ports to be configured.
This is the highest threshold for the alarm. When the operating parameter rises above this
value, action associated with the alarm will be taken.
This is the lowest threshold for the alarm. When the operating parameter falls below this
value, action associated with the alarm will be taken.
This is the highest threshold for the warning. When the operating parameter rises above this
value, action associated with the warning will be taken.
This is the lowest threshold for the warning. When the operating parameter falls below this
value, action associated with the warning will be taken.
37