Snmp User Table - D-Link xStack DGS-3400 Series Reference Manual

x Stack
To enable or disable linkchange trap settings for individual ports, select the ports using the From and To drop-down menus, enable
the State using the drop-down menu, and then click Apply.

SNMP User Table

This window displays all of the SNMP users currently configured on the Switch.
To view this window, click Administration > SNMP Manager > SNMP User Table, as shown below.
To delete an existing SNMP User Table entry, click the
delete.
To display the detailed entry for a given user, click the View button under the Display heading. This will open the SNMP User
Table Display window, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 119 SNMP User Table window
Figure 2 - 120 SNMP User Table - View window
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
V3 – Indicates that SNMP version 3 is in use.
None – Indicates that no authentication protocol is in use.
MD5 – Indicates that the HMAC-MD5-96 authentication level will be used.
SHA – Indicates that the HMAC-SHA authentication protocol will be used.
None – Indicates that no privacy (encryption) protocol is in use.
DES – Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56)
standard.
below the Delete heading corresponding to the entry you wish to
106