Ddm Status Table - D-Link xStack DGS-3400 Series Reference Manual

x Stack
The following parameters can be configured:
Parameter
Unit
From / To
High Alarm (0-
6.5535)
Low Alarm (0-
6.5535)
High Warnin (0-
6.5535)
Low Waring (0-
6.5535)
Click Apply to implement the changes.

DDM Status Table

This window is used to display the current operating digital diagnostic monitoring parameters and their values on the SFP module
for specified ports.
To view this window, click Administration > Port Configuration > DDM > DDM Status Table, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 26 DDM TX PowerThreshold Settings window
Description
Select the unit to configure.
Select a range of ports to be configured.
This is the highest threshold for the alarm. When the operating parameter rises above this
value, action associated with the alarm will be taken.
This is the lowest threshold for the alarm. When the operating parameter falls below this
value, action associated with the alarm will be taken.
This is the highest threshold for the warning. When the operating parameter rises above this
value, action associated with the warning will be taken.
This is the lowest threshold for the warning. When the operating parameter falls below this
value, action associated with the warning will be taken.
39