Transceiver And Cable Specifications; Determining Qfx10000 Optical Transceiver And Cable Support - Juniper QFX10016 Hardware Manual

CHAPTER 10

Transceiver and Cable Specifications

Determining QFX10000 Optical Transceiver and Cable Support

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Determining QFX10000 Optical Transceiver and Cable Support on page 127
Cable Specifications for QSFP+ and QSFP28 Transceivers on page 128
QFX10000 Cable Specifications for Console and Management Connections on page 129
Understanding QFX Series Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion on page 130
Calculating the Fiber-Optic Cable Power Budget for a QFX Series Device on page 131
Calculating the Fiber-Optic Cable Power Margin for a QFX Series Device on page 132
The QFX10000 line cards support optical transceivers, direct attach copper (DAC) cables,
and DAC breakout (DACBO) cables for uplinks, downlinks, or as access ports. The
QFX10000 Control Board also supports using small form-factor pluggable (SFP)
transceivers to connect the SFP management (
You can find information about the optical transceivers supported on your Juniper device
by using the Hardware Compatibility Tool. In addition to transceiver and connection type,
the optical and cable characteristics–where applicable–are documented for each
transceiver. The Hardware Compatibility Tool enables you to search by product, displaying
all the transceivers supported on that device, or category, by interface speed or type. The
list of supported transceivers for the QFX10008 line cards is located at
https://pathfinder.juniper.net/hct/product/#prd=QFX10008
cards at
https://pathfinder.juniper.net/hct/product/#prd=QFX10016
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
QFX10000-36Q Line Card on page 55
QFX10000-30C Line Card on page 61
) port.
MGMT
and for the QFX10016 line
.
127