Working With Multitool - Siemens SINUMERIK 840D sl Operating Manual

Tool management

13.15 Working with multitool

● Permitting tool in/out file
– When creating a new tool, the tool data can be loaded from a file.
– When deleting or unloading a tool, the tool data can be backed up to a file.
● Switch on adapter-transformed view
– Geometry lengths and the application offsets are displayed in a transformed manner in
– In the tool wear list, the wear length and the sum offsets are displayed in a transformed
References
For further information about configuring the settings, please refer to the following references:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
Procedure
...
13.15 Working with multitool
Using a multitool you have the possibility of storing more than one tool at a magazine location.
The multitool itself has two or more locations to accept tools. The tools are directly mounted
on the multitool. The multitool is located at a location in the magazine.
692
the tool list.
manner.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1. Select the "Parameter" operating area.
2. Press the "Tool list", "Tool wear" or "Magazine" softkey.
3. Press the "Continue" and "Settings" softkeys.
4. Activate the corresponding check box for the desired setting.
Operating Manual, 05/2017, A5E40868721
Turning