Siemens SINUMERIK 840D sl Operating Manual page 685

Parameter
Magazine location
Tool name
ST
D quantity
D
Tool type
Geometry
Wear
Geometry
Wear
For type 500 (rougher) and type 510 (finisher)
Cutting edge graphic
Reference direction
Holder angle
Cutting tip angle
Type 240 - tap
Pitch
Type 200 - twist drill, type 220 - centering tool and type 230 - countersink
Tip angle
Type 520 -plunge cutter, type 530 - parting tool, type 540 - threading tool
Cutting tip length
Cutting tip width
Type 110 - ball end mill for cylindrical die-sinking cutter, type 111 - ball end mill for tapered die-sinking cutter, type 120 - end
mill, type 121 - end mill with corner rounding, type 130 - angle head cutter, type 140 - facing tool, type 150 - side mill, type
155 - bevel cutter, type 156 - bevel cutter with corner rounding and type 157 - tapered die-sinking cutter
N
Turning
Operating Manual, 05/2017, A5E40868721
Meaning
The magazine number is specified first, followed by the location number in the magazine.
If there is only one magazine, only the location number is displayed.
The tool is identified by the name and the sister tool number. You can enter the name
as text or number.
Sister tool number (for replacement tool strategy)
Number of created cutting edges
Cutting edge number
Tool symbol with type number and current cutting edge position
Length X Length Z
Geometry data, length Geometry data, length Z
X
Length X wear Length Y wear
Radius
Tool radius
Radius wear
The cutting edge graphic shows the positioning defined by the
holder angle, cut direction and cutting tip angle.
The reference direction for the holder angle specifies the cut
direction.
To determine the cutting edge positioning
To determine the cutting edge positioning
For displaying the tools during the simulation of the program execution
Width of the plunge cutter
Number of teeth
Tool management
13.9 Tool details
685