Siemens SINUMERIK 840D sl Operating Manual page 531

Parameter Description
EW Note:
During insertion with oscillation, the message "Ramp path too short" will appear if the
tool is less than the milling cutter diameter away from the insertion point along the ramp.
If this occurs, please reduce the angle of insertion.
Lift mode Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can
be programmed:
● To retraction plane
● Z0 + safety clearance
When making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 (X0) in the pocket area, then Z0 (X0) + safety
clearance can be programmed as the lift mode.
FS Chamfer width for chamfering - (only for chamfering machining)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering machining only)
Parameters in the "Input simple" mode
G code program parameters
Input
PRG Name of the program to be generated
Milling direction ● Climbing
● Conventional
RP Retraction plane
F Feedrate
Parameter Description
Machining
● Face C
surface
● Face Y
● Face B
(only for ShopTurn)
● Peripheral surface C
● Peripheral surface Y
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for ShopTurn)
Turning
Operating Manual, 05/2017, A5E40868721
ShopTurn program parameters
● simple
T
D
mm F
* S / V
Programming technology functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant
cutting rate
10.5 Contour milling
Unit
Degrees
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
531