Siemens SINUMERIK 840D sl Operating Manual page 605

Parameter
Measurement unit
Main spindle
Work offset
Write to the
work offset
ZV
Blank
XA
XI
ZA
ZI
ZB
N
SW or L
W
L
S
Spindle chuck
data
Spindle chuck
data
ZC
Turning
Operating Manual, 05/2017, A5E40868721
Description
Selecting the measurement unit
Selecting the work offset
● Yes
Parameter ZV is displayed
● No
Parameter ZV is not displayed
Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please observe the information provided by the machine manufacturer.
● Tube
● Cylinder
● Polygon
● Centered cuboid
Outside diameter ∅ – for tube and cylinder
Inside diameter (abs) or wall thickness (inc) – only for tube
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Number of edges – only for polygon
Width across flats or edge length – only for polygon
Width of the blank - only for centered cuboid
Length of the blank - only for centered cuboid
Speed limitation of the main spindle
● Yes
You enter spindle chuck data in the program.
● No
Spindle chuck data is transferred from the setting data.
Note:
Please observe the information provided by the machine manufacturer.
● Only chuck
You enter spindle chuck data in the program.
● Complete
You enter tailstock data in the program.
Note:
Please observe the information provided by the machine manufacturer.
● The main spindle chuck dimensions - (only for spindle chuck data "yes")
Multi-channel machining
11.2 Multi-channel support
Unit
mm
inch
mm
mm
mm
mm
mm
mm
mm
rev/min
mm
605