10.1.10
10.1.11
10.1.12
10.1.13
10.1.14
10.1.15
10.1.16
Repeating positions..............................................................................................................348
10.2
Rotate...................................................................................................................................349
10.2.1
General................................................................................................................................349
10.2.2
Stock removal (CYCLE951).................................................................................................349
10.2.3
Groove (CYCLE930)............................................................................................................352
10.2.4
10.2.5
10.2.6
Thread turning (CYCLE99)..................................................................................................360
10.2.7
Thread chain (CYCLE98).....................................................................................................376
10.2.8
Cut-off (CYCLE92)...............................................................................................................381
10.3
Contour turning....................................................................................................................383
10.3.1
General information..............................................................................................................383
10.3.2
10.3.3
Creating a new contour........................................................................................................386
10.3.4
Creating contour elements...................................................................................................387
10.3.5
10.3.6
Changing the contour...........................................................................................................394
10.3.7
10.3.8
Stock removal (CYCLE952).................................................................................................396
10.3.9
10.3.10
Plunge-cutting (CYCLE952).................................................................................................408
10.3.11
10.3.12
10.3.13
10.4
Milling...................................................................................................................................425
10.4.1
Face milling (CYCLE61).......................................................................................................425
10.4.2
10.4.3
Circular pocket (POCKET4).................................................................................................438
10.4.4
10.4.5
Circular spigot (CYCLE77)...................................................................................................454
10.4.6
Multi-edge (CYCLE79).........................................................................................................460
10.4.7
10.4.8
10.4.9
Open groove (CYCLE899)...................................................................................................481
10.4.10
10.4.11
Thread milling (CYCLE70)...................................................................................................494
10.4.12
Engraving (CYCLE60)..........................................................................................................498
10.5
Contour milling.....................................................................................................................504
10.5.1
General information..............................................................................................................504
10.5.2
10.5.3
Creating a new contour........................................................................................................506
10.5.4
Creating contour elements...................................................................................................508
10.5.5
Changing the contour...........................................................................................................513
10.5.6
Turning
Operating Manual, 05/2017, A5E40868721
Table of contents
13