Tool List For Multitool - Siemens SINUMERIK 840D sl Operating Manual

Typical applications
One application for using multitools on lathes with revolver and counterspindle is to equip the
multitool with two turning tools. One turning tool for machining on the main spindle and one
turning tool for machining on the counterspindle.
An additional application is to use multitools on lathes equipped with a tool spindle. A multitool,
on which several tools have been mounted, is inserted in the tool spindle at this machine. A
tool change within the multitool is realized by positioning the multitool, i.e. by rotating the tool
spindle.
Geometrical arrangement of the tools on the multitool
The geometrical arrangement of the tools is defined by the clearance between the locations
on the multitool.
The clearance between the locations can be defined as follows:
● Using the multitool location number or
● using the angle of the multitool location
If angle is selected here, then the value of the angle must be entered for each multitool location.
Regarding loading and unloading in a magazine, the multitool is treated as a single unit.
13.15.1

Tool list for multitool

If you work with a multitool, the tool list is supplemented by the column for the multitool location
number. As soon as the cursor is at a multitool in the tool list, certain column headings change.
Column heading
Location
MT loc.
TYPE
Multitool name
Figure 13-19 Toll list with multitool in the spindle
Turning
Operating Manual, 05/2017, A5E40868721
Meaning
Magazine/location number
Multitool location number
Symbol for multitool
Name of the multitool
Tool management
13.15 Working with multitool
693