Multi-channel machining
11.2 Multi-channel support
11.2.5
Editing the multi-channel program
11.2.5.1
Changing the job list
You now have the option to change the composition of the programs and/or the assignment
of the channel and program in a job list.
Precondition
● "programSYNC" option
Procedure
11.2.5.2
Editing a G code multi-channel program
Editing a G code multi-channel program
Precondition
● The "programSYNC" option is set.
● In order to display the machining at the counterspindle at the correct position in the
simulation, the linear axis of the counterspindle must be positioned before CYCLE208
(multi-channel data).
610
1.
Select the "Program Manager" operating area.
2.
Select where the multi-channel program should be archived
3.
Position the cursor in the "Workpieces" folder on a job list and press the
"Open" softkey.
The window "Job list * JOB" is opened and the program assignment to
the channels is displayed.
4.
Select the channel to which you wish to assign a new program and press
the softkey "Select program".
The "Program" window is opened and displays all of the programs created
in the workpiece.
- OR -
Press the "Open job list" softkey.
Operating Manual, 05/2017, A5E40868721
Turning