Siemens SINUMERIK 840D sl Operating Manual page 665

...
The tool creation sequence can be defined differently.
Multiple load points
If you have configured several loading points for a magazine, then the "Select loading point"
window appears when a tool is created directly in an empty magazine location or when the
"Load" softkey is pressed.
Select the required load point and confirm with the "OK" softkey.
Additional data
If configured accordingly, the "New tool" window opens after the required tool has been
selected and confirmed with "OK".
You can define the following data in this window:
● Names
● Tool location type
● Size of tool
References:
For a description of configuration options, refer to the
SINUMERIK Operate Commissioning Manual
Turning
Operating Manual, 05/2017, A5E40868721
The "New tool - favorites" window opens.
- OR -
If you want to create a tool that is not in the Favorites list, press the
"Cutters 100-199", "Drills 200-299", "Turning tools 500-599" or "Sp.
tools 700-900" softkey.
The "New Tool - Milling Cutters", "New Tool - Drills", "New Tool - Turn‐
ing Tools" or "New Tool - Special Tools" window opens.
4. Select the tool by placing the cursor on the corresponding tool type and
on the icon of the desired cutting edge position.
5. If more than four cutting edge positions are available, select the desired
cutting edge position with the aid of the <cursor left> and <cursor right>
keys.
6. Press the "OK" softkey.
The tool is added to the tool list with a predefined name. If the cursor
is located on an empty magazine location in the tool list, then the tool
is loaded to this magazine location.
Tool management
13.5 Tool list
665