Siemens SINUMERIK 840D sl Operating Manual page 672

Tool management
13.5 Tool list
Unloading tool on code carrier
According to the appropriate setting, after being read out on the code carrier, the unloaded
tool on the code carrier is deleted from the NC memory.
Delete tool on code carrier
The deletion of the tool can be set differently, i.e. the "On code carrier" softkey is not available.
References
A description of the configuration options can be found in the following reference:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
672
1. The tool list is opened.
2. Place the cursor on the tool that you would like to unload from the mag‐
azine and press the "Unload" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are then written to the code
carrier.
1. The tool list is opened.
2. Position the cursor on the tool on code carrier that you want to delete.
3. Press the "Delete tool" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are written to the code carrier.
The tool is then deleted from the NC memory.
Operating Manual, 05/2017, A5E40868721
Turning