Configuring Anycast Rp - Dell S4048–ON Configuration Manual

S-series 10gbe switches

Hide thumbs Also See for S4048–ON:

Table of Contents

Figure 95. MSDP with Anycast RP

Configuring Anycast RP

To configure anycast RP, use the following commands.

In each routing domain that has multiple RPs serving a group, create a Loopback interface on each RP serving the group with

the same IP address.

CONFIGURATION mode

interface loopback

Make this address the RP for the group.

CONFIGURATION mode

ip pim rp-address

In each routing domain that has multiple RPs serving a group, create another Loopback interface on each RP serving the group

with a unique IP address.

CONFIGURATION mode

interface loopback

Peer each RP with every other RP using MSDP, specifying the unique Loopback address as the connect-source.

Multicast Source Discovery Protocol (MSDP)