Defining Interface Range Macros - Dell S4048–ON Configuration Manual

Create a Multiple-Range
The following is an example of multiple range.
Example of the interface range Command (Multiple Ranges)
Dell(conf)#interface range tengigabitethernet 1/5 - 1/10 , tengigabitethernet 1/1 , vlan
1
Dell(conf-if-range-te-1/1,te-1/5-1/10,vl-1)#
Exclude Duplicate Entries
The following is an example showing how duplicate entries are omitted from the interface-range prompt.
Example of the Interface-Range Prompt for Duplicate Interfaces
Dell(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
Dell(conf-if-range-vl-1,vl-3)#
Dell(conf)#interface range tengigabitethernet 2/1 - 2/23 , tengigabitethernet 2/1 - 2/23 ,
tengigab 2/1 - 2/23
Dell(conf-if-range-te-2/1-23)#
Exclude a Smaller Port Range
The following is an example show how the smaller of two port ranges is omitted in the interface-range prompt.
Example of the Interface-Range Prompt for Multiple Port Ranges
Dell(conf)#interface range tengigabitethernet 2/1 - 2/23 , gigab 2/1 - 2/10
Dell(conf-if-range-te-2/1-2/23)#
Overlap Port Ranges
The following is an example showing how the interface-range prompt extends a port range from the smallest start port number to
the largest end port number when port ranges overlap. handles overlapping port ranges.
Example of the Interface-Range Prompt for Overlapping Port Ranges
Dell(conf)#interface range tengigabitethernet 2/1 - 2/11 , gi 2/1 - 2/23
Dell(conf-if-range-te-2/1-23)#
Commas
The following is an example of how to use commas to add different interface types to the range, enabling TenGigabitEthernet
interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2.
Example of Adding Interface Ranges
Dell(config-if)# interface range tengigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2
Dell(config-if-range-te-5/1-23)# no shutdown
Dell(config-if-range-te-5/1-23)#
Add Ranges
The following example shows how to use commas to add VLAN and port-channel interfaces to the range.
Example of Adding VLAN and Port-Channel Interface Ranges
Dell(config-if-range-te-1/1-1/2)# interface range Vlan 2 – 100 , Port 1 – 25
Dell(config-if-range-te-1/1-1/2-vl-2-100-po-1-25)# no shutdown

Defining Interface Range Macros

You can define an interface-range macro to automatically select a range of interfaces for configuration.
Before you can use the macro keyword in the interface-range macro command string, define the macro.
To define an interface-range macro, use the following command.
• Defines the interface-range macro and saves it in the running configuration file.
CONFIGURATION mode
define interface-range macro_name {vlan vlan_ID - vlan_ID | {{tengigabitethernet |
fortyGigE} slot/port/[subport] - slot/port/[subport]}} [ , {vlan vlan_ID - vlan_ID |
385
Interfaces