Configuring Monitor Multicast Queue - Dell S4048–ON Configuration Manual

0 Te 1/1
Dell(conf)#monitor session 0
Dell(conf-mon-sess-0)#source po 10 dest ten 1/2 dir rx
Dell(conf-mon-sess-0)#do show monitor session
SessID Source
------ ------
0 Te 1/1
0 Po 10
Dell(conf)#monitor session 1
Dell(conf-mon-sess-1)#source vl 40 dest ten 1/3 dir rx
Dell(conf-mon-sess-1)#flow-based enable
Dell(conf-mon-sess-1)#exit
Dell(conf)#do show monitor session
SessID Source
------ ------
0 Te 1/1
0 Po 10
1 Vl 40
NOTE: Source as VLAN is achieved via Flow based mirroring. Please refer section
In the following example, the host and server are exchanging traffic which passes through the uplink interface 1/1. Port 1/1 is the
monitored port and port 1/42 is the destination port, which is configured to only monitor traffic received on tengigabitethernet 1/1
(host-originated traffic).
Figure 106. Port Monitoring Example

Configuring Monitor Multicast Queue

To configure monitor QoS multicast queue ID, use the following commands.
1. Configure monitor QoS multicast queue ID.
CONFIGURATION mode
Te 1/2 rx
Destination Dir
----------- ---
Te 1/2 rx
Te 1/2 rx
Destination Dir
----------- ---
Te 1/2 rx
Te 1/2 rx
Te 1/3 rx
Port N/A
Mode Source IP
---- ---------
Port N/A
Port N/A
Mode Source IP
---- ---------
Port N/A
Port N/A
Flow N/A
N/A
Dest IP
--------
N/A
N/A
Dest IP
--------
N/A
N/A
N/A
Enabling Flow-Based
Port Monitoring
Monitoring.
647