Dell S4048–ON Configuration Manual page 999

Figure 162. VRRP for IPv6 Topology
NOTE: This example does not contain comprehensive directions and is intended to provide guidance for only a typical
VRRP configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to
support your own IP addresses, interfaces, names, and so on.
NOTE: In a VRRP or VRRPv3 group, if two routers come up with the same priority and another router already has
MASTER status, the router with master status continues to be master even if one of two routers has a higher IP or IPv6
address.
Router 2
R2(conf)#interface tengigabitethernet 1/1
R2(conf-if-te-1/1)#no ip address
R2(conf-if-te-1/1)#ipv6 address 1::1/64
R2(conf-if-te-1/1)#vrrp-group 10
NOTE: You must configure a virtual link local (fe80) address for each VRRPv3 group created for an interface. The
VRRPv3 group becomes active as soon as you configure the link local address. Afterwards, you can configure the group's
virtual IPv6 address.
R2(conf-if-te-1/1-vrid-10)#virtual-address fe80::10
Virtual Router Redundancy Protocol (VRRP)
999