Copying A Configuration File - Dell S4048–ON Configuration Manual

MIB Object
copySrcFileName
copyDestFileType
copyDestFileLocation
copyDestFileName
copyServerAddress
copyUserName
copyUserPassword

Copying a Configuration File

To copy a configuration file, use the following commands.
NOTE: In UNIX, enter the snmpset command for help using the following commands. Place the
in the directory from which you are executing the snmpset command or in the snmpset tool path.
1. Create an SNMP community string with read/write privileges.
CONFIGURATION mode
806
Simple Network Management Protocol (SNMP)
OID
.1.3.6.1.4.1.6027.3.5.1.1.1.1.4
.1.3.6.1.4.1.6027.3.5.1.1.1.1.5
.1.3.6.1.4.1.6027.3.5.1.1.1.1.6
.1.3.6.1.4.1.6027.3.5.1.1.1.1.7
.1.3.6.1.4.1.6027.3.5.1.1.1.1.8
.1.3.6.1.4.1.6027.3.5.1.1.1.1.9
.1.3.6.1.4.1.6027.3.5.1.1.1.1.10
Object Values
Path (if the file is not in the
current directory) and filename.
1 = Dell Networking OS file
2 = running-config
3 = startup-config
1 = flash
2 = slot0
3 = tftp
4 = ftp
5 = scp
Path (if the file is not in the
default directory) and filename.
IP Address of the server.
Username for the server.
Password for the server.
Description
Specifies name of the file.
• If copySourceFileType is set
to running-config or
startup-config,
copySrcFileName is not
required.
Specifies the type of file to
copy to.
• If copySourceFileType is
running-config or startup-
config, the default
copyDestFileLocation is
flash.
• If copyDestFileType is a
binary, you must specify
copyDestFileLocation and
copyDestFileName.
Specifies the location of
destination file.
• If copyDestFileLocation is
FTP or SCP, you must
specify copyServerAddress,
copyUserName, and
copyUserPassword.
Specifies the name of
destination file.
The IP address of the server.
• If you specify
copyServerAddress, you
must also specify
copyUserName and
copyUserPassword.
Username for the FTP, TFTP,
or SCP server.
• If you specify
copyUserName, you must
also specify
copyUserPassword.
Password for the FTP, TFTP, or
SCP server.
f10-copy-config.mib file