Dell S4048–ON Configuration Manual page 715

Default version control: receive version 2, send version 2
Interface
TenGigabitEthernet
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance
Distance: (default is 120)
Dell#
To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for
sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.
Dell(conf-if)#ip rip send version 1 2
Dell(conf-if)#ip rip receive version 2
The following example of the show ip protocols command confirms that both versions are sent out that interface. This
interface no longer sends and receives the same RIP versions as Dell Networking OS does globally (shown in bold).
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 11
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface
TenGigabitEthernet 1/1
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance
Distance: (default is 120)
Dell#
Generating a Default Route
Traffic is forwarded to the default route when the traffic's network is not explicitly listed in the routing table.
Default routes are not enabled in RIP unless specified. Use the default-information originate command in ROUTER RIP
mode to generate a default route into RIP. In Dell Networking OS, default routes received in RIP updates from other routes are
advertised if you configure the default-information originate command.
• Specify the generation of a default route in RIP.
ROUTER RIP mode
default-information originate [always] [metric value] [route-map route-map-name]
– always: Enter the keyword always to always generate a default route.
– value The range is from 1 to 16.
– route-map-name: The name of a configured route map.
To confirm that the default route configuration is completed, use the show config command in ROUTER RIP mode.
Recv Send
1/1 2 2
Last Update
Recv Send
2 1 2
Last Update
Routing Information Protocol (RIP)
715