Enabling Snmp Traps For Root Elections And Topology Changes; Modifying Interface Parameters - Dell S4048–ON Configuration Manual

PROTOCOL SPANNING TREE RSTP mode
hello-time seconds
NOTE: With large configurations (especially those configurations with more ports) Dell Networking recommends
increasing the hello-time.
The range is from 1 to 10.
The default is 2 seconds.
• Change the max-age parameter.
PROTOCOL SPANNING TREE RSTP mode
max-age seconds
The range is from 6 to 40.
The default is 20 seconds.
To view the current values for global parameters, use the show spanning-tree rstp command from EXEC privilege mode.

Enabling SNMP Traps for Root Elections and Topology Changes

To enable SNMP traps, use the following command.
• Enable SNMP traps for RSTP, MSTP, and PVST+ collectively.
snmp-server enable traps xstp

Modifying Interface Parameters

On interfaces in Layer 2 mode, you can set the port cost and port priority values.
• Port cost — a value that is based on the interface type. The previous table lists the default values. The greater the port cost,
the less likely the port is selected to be a forwarding port.
• Port priority — influences the likelihood that a port is selected to be a forwarding port in case that several ports have the same
port cost.
To change the port cost or priority of an interface, use the following commands.
• Change the port cost of an interface.
INTERFACE mode
spanning-tree rstp cost cost
The range is from 0 to 65535.
The default is listed in the previous table.
• Change the port priority of an interface.
INTERFACE mode
spanning-tree rstp priority priority-value
The range is from 0 to 15.
The default is 128.
To view the current values for interface parameters, use the show spanning-tree rstp command from EXEC privilege mode.
Rapid Spanning Tree Protocol (RSTP)
731