Copp For Ospfv3 Packets - Dell S4048–ON Configuration Manual

The basics for creating a CoPP service policy is to create QoS policies for the desired CPU bound queue and associate it with a
particular rate-limit. The QoS policies are assigned to a control-plane service policy for each port-pipe.
1. Create a QoS input policy for the router and assign the policing.
CONFIGURATION mode
qos-policy-input name cpu-qos
2. Create an input policy-map to assign the QoS policy to the desired service queues.l.
CONFIGURATION mode
policy-map--input name cpu-qos service-queue queue-number qos-policy name
On the Z9500, the range of queue-number values is from 0 to 23. The twenty-four control–plane queues are divided into
groups of eight queues for the Route Processor, Control Processor, and line-card CPUs as follows:
• Queues 0 to 7 process packets destined to the Control Processor CPU .
• Queues 8 to 15 process packets destined to the Route Processor CPU.
• Queues 16 to 23 process packets destined to the line-card CPU.
3. Enter Control Plane mode.
CONFIGURATION mode
control-plane-cpuqos
4. Assign a CPU queue-based service policy on the control plane in cpu-qos mode. Enabling this command sets the queue rates
according to those configured.
CONTROL-PLANE mode
service-policy rate-limit-cpu-queues input-policy-map
Examples of Configuring CoPP for CPU Queues
The following example shows creating the QoS policy.
Dell#conf
Dell(conf)#qos-policy-input cpuq_1
Dell(conf-qos-policy-in)#rate-police 3000 40 peak 500 40
Dell(conf-qos-policy-in)#exit
Dell(conf)#qos-policy-input cpuq_2
Dell(conf-qos-policy-in)#rate-police 5000 80 peak 600 50
Dell(conf-qos-policy-in)#exit
The following example shows assigning the QoS policy to the queues.
Dell(conf)#policy-map-input cpuq_rate_policy cpu-qos
Dell(conf-qos-policy-in)#service-queue 5 qos-policy cpuq_1
Dell(conf-qos-policy-in)#service-queue 6 qos-policy cpuq_2
Dell(conf-qos-policy-in)#service-queue 7 qos-policy cpuq_1
The following example shows creating the control plane service policy.
Dell#conf
Dell(conf)#control-plane
Dell(conf-control-plane)#service-policy rate-limit-cpu-queues cpuq_rate_policy

CoPP for OSPFv3 Packets

You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP.
You can use the ipv6 access-list name cpu-qos permit ospfv3 command to allow CoPP traffic for OSPFv3. Control
Plane Policing (CoPP) enables more number of CPU queues to be made available on ports for IPv6 and ICMPv6 packets.
Control Plane Policing (CoPP)
235