Table of Contents
Advertisement
HOW TO USE THIS MANUAL
Switch 09 - Various
Digit
Memory lock
(Feature Expander Required)
0, 1
2 to 7
Do not change these settings.
Switch 10 Various
Digit
0
Reverse order printing (Feature Expander Required) 0: Off
1 to 6
Do not change these settings
Halftone mode
7
Switch 11 Various
Digit
0 to 5
Do not change these settings.
Printing the received message when it is acted as a forwarding station.
6
7
Polling standby duration
Switch 12 Various
Digit
0 and 1
Do not change these settings.
Toner saving mode
Note:
If on, contrast will be set to "Normal" automatically, preserving image quality.
This is available when receiving fax messages and printing reports, but not for
copying or printing from a PC.
2
Further, messages sent to you in halftone mode will automatically turn off toner
saving to insure a clear image.
To make sure that the fax quality is acceptable with toner saving on, print a few
reports. (See page 172.)
(Note: If the sender is using a machine made by another manufacturer, toner saving
will stay on and this could lower image quality.)
Density of the printing image
3 and 4
5 to 7
Do not change these settings.
14
Purpose
Digit 1 Digit 0 Setting
X
0
Off
0
1
Messages from senders whose
RTI/CSI are programmed are not
printed unless you enter the memory
lock ID.
1
1
Messages from senders whose
RTI/CSI are not programmed are not
printed unless you enter the memory
lock ID.
Purpose
0: Standard Mode
1: Speed Mode
Purpose
0: Off
0: Once
Purpose
0: Off
Digit 4 Digit 3 Setting
0
0
Normal
1
0
Darken
1: On
1: On
1: Keep
1: On
Digit 4 Digit 3 Setting
0
1
Lighten
1
1 Do not use
these settings
Advertisement
Table of Contents
