Symmetricom TimeCreator 1000 User Manual page 260

Appendix B Command Descriptions and Communications Interface
CLI Commands
Set-timeout
Use this command to change the timeout time. If the timeout is reached, the CLI
logs out with a message "Session timeout" ... The user can set the timeout as
desired.
Command Syntax:
set-timeout <value>
Example:
To set the timeout time to a value of 900 seconds:
tc1000>set-timeout 900
Remarks: The range for the session timeout parameter is 30  3600 seconds.
TimeCreator will accept the
users, but TimeCreator will return the message "Unable to open configuration file to
record timeout value". The value entered by Level 1 or Level 2 users will only apply
to the session in which the command was entered.
Level : Power-User and Admin only
260 TimeCreator 1000 User's Guide
command from Level 1 and Level 2
set-timeout
097-93100-01 Revision C – February, 2010