Symmetricom TimeCreator 1000 User Manual page 247

Set Root-recovery Rapidrecovery
This command is used to enable or disable the rapid recovery mode, enable or
disable the rapid recovery mode for all ports, and enable or disable the rapid
recovery mode on a per port basis (1 through 12).
Note: This command is only applicable for a TimeCreator 1000 that is
being used as a root server.
Command Syntax:
set root-recovery rapidrecovery [port#|all] [enable|disable]
Example:
To enable the rapid recovery mode for root server recovery on Port 5:
tc1000> set root-recovery rapidrecovery port5 enable
Related:
show root-recovery config
Level : Power-User and Admin only
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
'
CLI Commands
TimeCreator 1000 User's Guide 247