Show Interface - Symmetricom TimeCreator 1000 User Manual

Show Interface

This command displays the port state (enabled or disabled) for the GPS, client, or
server ports. It also displays the reference priorities and the port number, type, test
mode, and state.
Note: With the 8-port IOC module option, only DTI Ports 1 through 6
are active, in addition to Port A/11 and Port B/12.
Command Syntax:
show interface
Example:
tc1000>show interface
Response:
Interface State
---------------------------------
|Port
|----------|--------------------|
|GPS
|..........|....................|
|Port1
|..........|....................|
|Port2
|..........|....................|
|Port3
|..........|....................|
|Port4
|..........|....................|
|Port5
|..........|....................|
|Port6
|..........|....................|
|Port7
|..........|....................|
|Port8
|..........|....................|
|Port9
|..........|....................|
|Port10
|..........|....................|
|PortA/11
|..........|....................|
|PortB/12
---------------------------------
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
|State
|disable
|enable
|enable
|enable
|enable
|enable
|enable
|disable
|disable
|disable
|disable
|enable
|enable
|
|
|
|
|
|
|
|
|
|
|
|
|
|
TimeCreator 1000 User's Guide 211
CLI Commands