Symmetricom TimeCreator 1000 User Manual page 161

Table A-8. TimeCreator 1000 Event Trap Details (Continued)
Trap Name
(trapID)
RSREN
1.3.6.1.4.1.9070.1.2.4.1.100.2.54
RSREX
1.3.6.1.4.1.9070.1.2.4.1.100.2.55
RSRAB
1.3.6.1.4.1.9070.1.2.4.1.100.2.56
See Table A-9
The OID for events traps are of the format
where y corresponds to index values that identify specific events. The digits shown
for the OID Index in
the full OID for each event.
Note: The ID in the Trap OID Name column in
used with the
tc1000>generate message
"id,trapAID1,trapAID2,trapState,trapValue"
If trapAID1 corresponds to the IOC module number,1 or 2, use the
value trapAID1=257 for IOC1 and trapAID2=258 for IOC2. Use the
number "0" for entries of "n/a".
Example
To generate the message for the trap "IOC <#> has transitioned in to
Holdover Mode", which has id=13, trapAID1=258 (corresponds to
trapAID1=2 for IOC2 in
trapValue=0:
tc1000>generate message "13,258,0,2,0"
The event trap is for information only and always has the nonalarm severity.
097-93100-01 Revision C – February, 2010
OID
below for additional trap details, such as descriptions and bindings.
Event OID = 1.3.6.1.4.1.9070.1.2.4.1.100.1.y
Table A-9 below correspond to y. See
Generate Message
Table
Appendix A Alarms, Events and SNMP Traps
Trap OID
Name
trapEnterAutoRecovery
trapExitAutoRecovery
trapAbortAutoRecovery
Table A-8
Table A-9
command to raise a specific trap -
A-9)
trapAID2=0, trapState=2, and
TimeCreator 1000 User's Guide 161
SNMP Traps
Trap
Severity
nonalarm
nonalarm
nonalarm
for listings of
below is