Show DTI-Clock
This command displays the date, time, leap seconds, and local time offset
transmitted on the DTI ports.
Command Syntax:
show dti-clock
Example:
tc1000>show dti-clock
Response:
DTI Time: 2010-01-13 07:35:24
Leap seconds: 14
Remarks: If the Show Clock command and the Show DTI-Clock command
time/date values are different and the unit is not in warm-up, then a "jam-sync" is
probably required.
Related:
show clock, set clock
Level :
User, Power-User and Admin
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
TimeCreator 1000 User's Guide 199