Symmetricom TimeCreator 1000 User Manual page 219

Show IOC-State
This command displays the state of both the active and standby
cannot assume the active, standby, or disabled state, the state indicates
IOC module
NOT AVAILABLE.
Command Syntax:
show ioc-state
Example:
tc1000>show ioc-state
Response:
--------------------------
|IOC
|--------|---------------|
|1
|........|...............|
|2
--------------------------
Remarks: The active
the standby Module.
Related:
set ioc-state
Level : User, Power-User and Admin
Set IOC-State
Use this command to provision the standby module to become the active module, or
for either module to be disabled. IOC1 references the
IMC and IOC2 references the
Command Syntax:
set ioc-state [active|standby|disable][IOC1|IOC2]
Example:
To set the standby module IOC2 to become the active module -
tc1000>set ioc-state active IOC2
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
|State |
|active |
|standby |
generates DTI outputs. The redundant module is
IOC module
IOC module
IOC module
to the right of the IMC.
TimeCreator 1000 User's Guide 219
CLI Commands
. If either
IOC module
to the left of the