Aborting Root Server Recovery - Symmetricom TimeCreator 1000 User Manual

Chapter 5 Provisioning
Provisioning Root Server Recovery Mode
how long re-alignment will take, in minutes (displays total time required, but does

not count down remaining time for re-alignment)
Note:
for all ports or for each individual port
Example:
Root recovery status in the root server can be retrieved by using the following
query:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
show root-recovery status
Enabling Rapid Recovery Mode
If the user decides that a shorter recovery is necessary, enter the following
command at the root server:
Set root-recovery rapidrecovery {port #|all} {enable | disable}
The Rapid Recovery mode can shorten the duration of the recovery process by at
least a factor of 10, depending on the phase error of the subtending server as a
result of the outage duration.
Example:
Rapid recovery mode can be enabled for all ports of the root server by using the
following commands:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
show root-recovery status
root server recovery process and expected time for re-alignment.
3. Type
set root-recovery rapidrecovery all enable

Aborting Root Server Recovery

Use the command "set root-recovery autorecoverymode abort " to abort the root
server recovery process.
102 TimeCreator 1000 User's Guide
If a shorter recovery is necessary, enable rapid recovery
and press Enter.
and press Enter to verify the status of the
and press Enter.
097-93100-01 Revision C – February, 2010