Symmetricom TimeCreator 1000 User Manual page 221

Show IP
This command displays the Host address, Mask, and Gateway IP settings for both
Ethernet interfaces. It also indicates if DHCP is enabled for the interface and if the
interface is disabled.
Command Syntax:
show ip {config | status}
Example 1:
To display the IP configuration -
tc1000>show ip config
Response 1:
eth0 config:
eth1 config:
Example 2:
To display the IP status -
tc1000>show ip status -
Response 2:
eth0: negotiated 100baseTx-FD flow-control, link ok
eth1: negotiated 100baseTx-FD flow-control, link ok
eth0
Mask:255.255.255.0
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
mode: dhcp
addr: 192.168.5.62
netmask: 255.255.255.0
broadcast: 192.168.5.255
gateway: 192.168.5.1
mode: static
addr: 10.0.0.101
netmask: 255.255.255.0
broadcast: 10.0.0.255
Link encap:Ethernet
inet addr:192.168.5.62
UP BROADCAST NOTRAILERS RUNNING MULTICAST
RX packets:2238869 errors:0 dropped:0 overruns:0 frame:0
TX packets:4798 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:139427807 (132.9 Mb)
Interrupt:9 Base address:0xc000
HWaddr 00:B0:AE:01:25:85
Bcast:192.168.5.255
TX bytes:452343 (441.7 Kb)
TimeCreator 1000 User's Guide 221
CLI Commands
MTU:1500 Metric:1