Table of Contents
Advertisement
How to install your GPS antenna
See
"Installing the GPS Antenna" on page
How to acquire and install SymmTime™
To acquire SymmTime, download this free software from
http://www.ntp-systems.com/symmtime.asp
Directions on its installation are found in
Use the quick "How to" guide
This is found in
How to change the root password
The S100 is shipped with a default root password of
a very good idea to change that password immediately.
To change the root password, use the following steps:
1.
Use HyperTerminal or Tera Term (included on the enclosed CD) on the serial port, or
SecureShell using PuTTY (included on the enclosed CD). Log in as User
Password
2. Type the command
3.
You will be prompted to type your new password, and then to type it again to confirm.
This is what you will see:
[root@syncserv1 /root]# passwd
New UNIX password:
Retype new UNIX password:
passwd: all authentication tokens updated successfully
[root@syncserv1 /root]#
Note:
and numbers, and no common words. So if you use a recognizable word as the new pass-
word, you may get an error message that looks like this:
[root@syncserv1 /root]# passwd
New UNIX password:
BAD PASSWORD: it is based on a dictionary word
Retype new UNIX password:
S100 User Guide – Rev. D – June 2005
"Introduction and Overview" on page 1
.
symmetricom
, all lower-case (UNIX commands are always case-sensitive).
passwd
The password command "prefers" passwords containing a random variety of letters
23.
"Installing SymmTime" on page
of this book.
symmetricom
2
49.
3
. For security reasons, it is
with
root
5
115
Advertisement
Chapters
Table of Contents
