Rack-Mounting The Cisco Asr 1002-F Router - Cisco ASR 1013 Hardware Installation Manual

Cisco ASR 1002-F Router Overview and Installation
Note Make certain that the cable-management bracket "U" feature device has the open end pointing upwards when
you attach it to the chassis
Figure 125: Attaching the Cable-Management Brackets to the Cisco ASR 1002-F Router
1
2
Step 8
Screw the cable-management brackets to each side of the rack-mount brackets already attached to the chassis. Use two
screws for each cable-management bracket.
Step 9 Check that all the screws are securely tightened.
What to Do Next
Go to the

Rack-Mounting the Cisco ASR 1002-F Router

The Cisco ASR 1002-F Router can be installed in an existing rack with equipment or in an empty rack with
no equipment. The chassis can be mounted in two equipment rack types:
• Two-post rack, 19-inch or 23-inch equipment rack. Inner clearance (the width between the inner sides
Cable-management bracket
top screw hole and bottom
screw hole
Cable-management bracket
"U" feature
Attaching a Chassis Ground Connection, on page 302
of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches
(8.8 cm). Airflow through the chassis is from front to back
.

Rack-Mounting the Cisco ASR 1002-F Router

3
—
to continue the installation.
Cisco ASR 1000 Series Router Hardware Installation Guide
Chassis front rack-mount
bracket
—
291