Cisco ASR 1013 Hardware Installation Manual page 635

Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
DETAILED STEPS
Step 1 There are two power supplies installed. At the rear of the chassis, check whether the power switch on the chassis is in
the Standby position.
Do not install the Cisco ASR 1001 Router power supplies without the top cover on the Cisco ASR 1001
Warning
chassis.
The following figure shows the Cisco ASR 1001 Router AC power supply standby switch.
Figure 301: Cisco ASR 1001 Router AC Power Supply Standby Switch
1
Installing the AC Power Supply into Cisco ASR 1001 Router
Cisco ASR 1001 Router AC power supply Standby switch.
This switch does not disconnect power from the power
source.
Cisco ASR 1000 Series Router Hardware Installation Guide
601