Cisco ASR 1013 Hardware Installation Manual page 484

Removing AC Power Supply from the Cisco ASR 1001 Router
SUMMARY STEPS
1. Unplug the power cable from the power source.
2. To remove the power cord from PS1, position the power supply cable in order to access the power supply
fasteners. Hold back the power supply cable in PS0, as shown in the following image, ensuring that you
do not unplug the power cable.
3. Continue to hold back the power supply cable in PS0, to gain access to the fastener. Unscrew both fasteners
on the power supply in slot 1.
4. After the power supply fasteners are loosened, grasp the handle with one hand, support the weight of the
power supply with the other hand, and pull the power supply out of the slot. The following image shows
how to remove the Cisco ASR 1001 Router AC power supply cables.
5. Repeat these steps to remove the AC power supply from Slot PS0.
DETAILED STEPS
Step 1 Unplug the power cable from the power source.
Step 2
To remove the power cord from PS1, position the power supply cable in order to access the power supply fasteners. Hold
back the power supply cable in PS0, as shown in the following image, ensuring that you do not unplug the power cable.
Figure 218: Positioning the AC Power Supply Cable in Slot PS0
Step 3 Continue to hold back the power supply cable in PS0, to gain access to the fastener. Unscrew both fasteners on the power
supply in slot 1.
The Cisco ASR 1001 power supplies are long and narrow. It is recommended that when you pull the power supply
Tip
out of the chassis, you support the power supply from the bottom with the other hand.
Cisco ASR 1000 Series Router Hardware Installation Guide
450
Cisco ASR 1001 Router Overview and Installation