Attaching Cable Retention Bracket On Ac Power Supply - Cisco ASR 1013 Hardware Installation Manual

Attaching Cable Retention Bracket on AC Power Supply

• To reduce the chance of interference, avoid crossing high-power lines with any interface cables.
• Verify all cabling limitations (particularly distance) before powering on the system.

Attaching Cable Retention Bracket on AC Power Supply

This section explains how to attach the cable retention bracket on AC power supply of the chassis.
The following image shows the cable retention bracket attaching to the AC power supply.
Figure 195: Cable Retention Bracket Attaching to the AC Power Supply
SUMMARY STEPS
1. Remove the two M3X5mm screws and discard.
2. Install AC cord retainer by inserting tabs into lance features on panel.
3. Secure AC cord retainer with two M3X8mm screws included in kit.
4. Connect AC power cord.
5. Secure AC cord by tightening retainer screw.
Cisco ASR 1000 Series Router Hardware Installation Guide
404
Cisco ASR 1013 Router Overview and Installation