Cisco Asr 1013 Router Power Zones - Cisco ASR 1013 Hardware Installation Manual

Cisco ASR 1013 Router Power Zones

2
3
4
5
Cisco ASR 1013 Router Power Zones
Internal fans draw cooling air into the chassis and across internal components to maintain an acceptable
operating temperature. (See the preceding figure.) The fans are built into the power supply allowing fan and
power supply replacement. A two-hole grounding lug is located on the bottom rear of the chassis (see the
preceding figure, callout 6). Four power supplies, either AC power supplies or DC power supplies, are accessed
from the rear of the router. The power supply bays are numbered from bottom to top: 0, 1, 2, and 3 respectively.
The Cisco ASR 1013 Router has two power zones:
• Power zone 1(top half of chassis) includes slots:
• Power zone 0 (bottom half of chassis) includes slots:
Do not combine AC and DC power supplies in the same chassis.
Note
Note Cisco ASR 1013 Router supports only Cisco ASR1000-RP2.
Cisco ASR 1000 Series Router Hardware Installation Guide
370
Forward rack-mount ears
are shipped installed
Chassis handle
Rear rack-mount brackets
AC power supply in slot
3 (power supply zone 1)
◦ PS1-A
◦ PS1-B
◦ Carrier card slots 3, 4, and 5
◦ RP1
◦ FP1
◦ PS0-A
◦ PS0-B
◦ Carrier card slots 0, 1, and 2
◦ RP0
◦ FP0
Cisco ASR 1013 Router Overview and Installation
7 AC power supply in slot
1 (power supply zone 0)
8 AC power supply in slot
0 (power supply zone 0)
9 Chassis ground stud
— —