Rack-Mounting The Cisco Asr 1002 Router - Cisco ASR1002 Installation Manual

Rack-Mounting the Cisco ASR 1002 Router

Figure 8-10
1
2
Screw the cable-management bracket to each side of the rack-mount brackets already attached to the
Step 6
chassis. Use two screws for each cable-management bracket. Use the package of four screws.
Step 7 Check that all screws are securely tightened.
Go to the
Step 8
Rack-Mounting the Cisco ASR 1002 Router
The Cisco ASR 1002 Router can be installed in an existing rack with equipment or in an empty rack with
no equipment: The chassis can be mounted in either rack types:
•
•
When handling the chassis, always follow proper lifting practices. See the
Note
section on page
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-16
Attaching the Cable-Management Brackets to the Cisco ASR 1002 Router
3
2
Cable-management bracket top and bottom
screw
Cable-management bracket
"Attaching a Chassis Ground Connection" section on page 8-25
Two-post rack, either 19 inch or 23 inch. Inner clearance (the width between the inner sides of the
two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches
(8.8 cm). Airflow through the chassis is from front to back.
If you are using a two-post rack secure the rack to the floor surface to prevent tipping and
Note
avoid bodily.
Four post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches (8.8
cm). Airflow through the chassis is from front to back.
5-23.
Chapter 8
1
CON
AUX
MGM T
LINK
MTS
CAR RIER
BOO T
QE3
QE2
QE1
QE0
STA T
AS R 10 02
mi n
sta t
ma j
pw r
OS
SPA -4XO C3-P
cri t
1
3 Chassis front rack-mount bracket
— —
Cisco ASR 1002 Router Overview and Installation
SPA -4XO C3-P OS
T
PWR STA
OS
SPA -4XO C3-P
to continue the installation.
"Chassis-Lifting Guidelines"
OL-13208-09