Cisco Asr 1002 Router Slot Numbering - Cisco ASR 1013 Hardware Installation Manual

Rear View
c_Rear_View_1271213.xml shows the Cisco ASR 1002 Router DC power supply.
Figure 81: Cisco ASR 1002 Router DC Power Supply
1
2
3
4
5
Internal fans draw cooling air into the chassis and across internal components to maintain an acceptable
operating temperature. The fans are located at the rear of the chassis. A two-hole grounding lug is located on
the side of the chassis. Two power supplies, either two AC power supplies or two DC power supplies are
accessed from the rear of the router.
Use only AC power supplies or DC power supplies in the Cisco ASR 1002 Router. Do not mix power
Caution
supply types.

Cisco ASR 1002 Router Slot Numbering

The Cisco ASR 1002 Router contains one Cisco embedded ASR1002-RP1 which is addressed as R0 and one
Cisco ASR1000-ESP5 or ASR1000-ESP10 forwarding processor in slot F0. The Cisco ASR 1002 Router
consists of an embedded ASR1000-RP1 and embedded ASR1000-SIP10 board supporting three half-height
SPAs or 1half-height and one full-height SPA and one Cisco ASR1000-ESP5 forwarding processor.
The SPA bays are bay 1, bay 2, and bay 3. The built-in 4xGE SPA ports are located in the SPA 0 location
and will be addressed as GE 0/0/x. The Cisco ASR 1002 Router provides a built-in 4-Gigabit Ethernet interface
Cisco ASR 1000 Series Router Hardware Installation Guide
222
Chassis ESD socket 6
DC power supply slot 0 7
label
DC power supply switch 8
Standby/On (|)
DC power supply LEDs 9
Power supply fan 10
Cisco ASR 1002 Router Overview and Installation
DC power supply captive
installation screw
DC power supply slot 1
label
Ground lead
Positive lead
Negative lead