Floor Loading Considerations - Cisco ASR 1013 Hardware Installation Manual

Floor Loading Considerations

• Cisco ASR 1004 Router:
• Cisco ASR 1006 Router:
• Cisco ASR 1013 Router:
Floor Loading Considerations
Ensure that the floor under the rack supporting the Cisco 1000 Series Routers is capable of supporting the
combined weight of the rack and all other installed equipment.
To assess the weight of the fully configured Cisco 1000 Series Router respectively, refer to the table in
Characteristics, on page 120
For additional information about floor loading requirements, consult the document GR-63-CORE, Network
Equipment Building System (NEBS) Requirements: Physical Protection .
Cisco ASR 1000 Series Router Hardware Installation Guide
122
◦ Cable-management brackets allow a bend radius of 1.5 in. (38.1 mm) for cables
◦ Adjustable rack-mount brackets allow for a front to rear rail variance distance of 15.50 in./394 mm
to 19.00 in./482.6 mm
◦ Chassis height meets EIA-310 rack spacing 4RU (6.95 in./176.53 mm), universal rack-mount
◦ Chassis width meets EIA-310 19-in. (17.25 in./438.15 mm) wide with rack brackets
◦ Cable-management brackets at each Cisco ASR 1000 Series SPA Interface (SIP) locations can
hold 16 ports of STP/UTP RJ 45 cables
◦ Cable-management brackets allow a bend radius of 1.5 in. (38.1 mm) for cables
◦ Adjustable rack-mount brackets allow for a front to rear rail variance distance of 15.50 in./394 mm
to 19.00 in. /482.6 mm
◦ Chassis height meets EIA-310 rack spacing 6RU (10.47 in./266 mm), universal rack-mount
◦ Chassis width meets EIA-310 19-in. (17.25 in./438.15 mm) wide with rack brackets
◦ Cable-management brackets at each Cisco ASR 1000 Series SPA Interface (SIP) locations can
hold 16 ports of STP/UTP RJ 45 cables
◦ Cable-management brackets allow a bend radius of 1.5 in. (38.1 mm) for cables
◦ Adjustable rack-mount brackets allow for a front to rear rail variance distance of 15.50/394mm to
19.00/482.6mm
◦ Chassis height meets EIA-310 rack spacing 13RU (22.8 in./579.12 mm), universal rack-mount
◦ Chassis width meets EIA-310 19-in. (17.25 in./438.15 mm) wide with rack brackets
◦ Cable-management brackets allow a bend radius of 1.5 in. (38.1 mm) for cables
◦ Adjustable rack-mount brackets allow for a front to rear rail variance distance of 15.50/394mm to
19.00 in./482.6 mm
◦ Ships with forward rack-mount brackets installed and an extra set in the accessory kit
section.
Preparing Your Site for Installation
Physical