Cisco Asr 1001 Router Faceplate Common Components - Cisco ASR 1013 Hardware Installation Manual

Cisco ASR 1001 Router Faceplate Common Components

3
4
5
Note For detailed descriptions of the SPAs on which some of the IDCs are based, go to:
en/US/products/ps6267/products_data_sheets_list.html
There are two field-replaceable units in the Cisco ASR 1001 chassis. They are the DIMMs and eUSB. In
Note
order to service the components in the chassis, you must remove the power supplies and the chassis cover.
For instructions, see the "Removing and Replacing the Cisco ASR 1001 Router DIMM Memory Modules"
and the "Remove and Replace the eUSB Device on the Cisco ASR 1001 Router" sections in the Removing
and Replacing FRUs from the Cisco ASR 1000 Series Routers chapter.
Cisco ASR 1001 Router Faceplate Common Components
The Cisco ASR 1001 Router RP faceplate has common components for each type of ASR 1001 Router
configuration. The preceding image and the following image show the Cisco ASR1000-RP faceplate with
LEDs and connectors for all configurations of the Cisco ASR 1001 Router.
Figure 202: Common Connectors for Cisco ASR 1001 Route Processor
Cisco ASR 1000 Series Router Hardware Installation Guide
416
USB port— one USB 8
high-speed (480Mbps)
port used for secure key
storage, storing of VPN
credentials, or bulk flash
storage for image and
configuration backup
USB LED 9
LINK LED indicates —
MGMT Ethernet port
activity
Cisco ASR 1001 Router Overview and Installation
STAT—status LED
PWR—Power LED
—
http://www.cisco.com/