Table of Contents
Advertisement
Views
Layer 2 aggregate interface view
Layer 2 Ethernet interface view
Management Ethernet interface view
Predefined user roles
network-admin
Parameters
agent: Specifies an LLDP agent type. If no agent type is specified in Ethernet interface view, the
command configures the operating mode for nearest bridge agents.
nearest-customer: Specifies nearest customer bridge agents.
nearest-nontpmr: Specifies nearest non-TPMR bridge agents.
disable: Specifies the Disable mode. A port in this mode cannot send or receive LLDP frames.
rx: Specifies the Rx mode. A port in this mode can only receive LLDP frames.
tx: Specifies the Tx mode. A port in this mode can only send LLDP frames.
txrx: Specifies the TxRx mode. A port in this mode can send and receive LLDP frames.
Examples
# Configure the LLDP operating mode as Rx for the nearest customer bridge agents on
GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp agent nearest-customer admin-status rx
lldp check-change-interval
Use lldp check-change-interval to enable LLDP polling and set the polling interval.
Use undo lldp check-change-interval to restore the default.
Syntax
In Layer 2 Ethernet interface view or management Ethernet interface view:
lldp [ agent { nearest-customer | nearest-nontpmr } ] check-change-interval interval
undo lldp [ agent { nearest-customer | nearest-nontpmr } ] check-change-interval
In Layer 2 aggregate interface view:
lldp agent { nearest-customer | nearest-nontpmr } check-change-interval interval
undo lldp agent { nearest-customer | nearest-nontpmr } check-change-interval
Default
LLDP polling is disabled.
Views
Layer 2 aggregate interface view
Layer 2 Ethernet interface view
Management Ethernet interface view
Predefined user roles
network-admin
270
Advertisement
Table of Contents
