Removable Hard Disk Interface Board Removal for Serial Prefix MY442 and
Removable Hard Disk Interface Board Removal for Serial
Prefix MY442 and above
Tools Required
•
TORX screwdriver, T10, T15, and T20
Removal procedure
Refer to Figure 6-8 for this procedure.
Step 1. Remove the outer cover as described in "Outer Cover Removal" on page 176.
Step 2. Remove the four TORX T10 screw (item 1).
Step 3. Unscrew the four TORX T10 screw (item 2) that hold the removable hard disk.
Step 4. Carefully remove the flat cable (item 3) . Release the cable's connector by pressing the
locking hooks at the sides of the connector.
Step 5. Lift the removable hard disk with the flat cable.
Step 6. Remove the two TORX T10 screw (item 4).
Step 7. Remove the inner cover.
Step 8. Turn over the removable hard disk case. Disconnect the power cable (item 5) and flat cable
(item 6) .
Step 9. Remove the four TORX T10 screw (item 7).
Replacement Procedure
Step 1. Replace the removable hard disk interface by inverse procedure of removal.
Chapter 6
Replacement Procedure
above
187